Wuhai Accumulation Gate Fast Gate Customized Free View of the Site
福建11选5走势图 In the whole process of purchasing express doors, reconnaissance site is a very important link. Only professional technicians can customize the production plan according to the actual situation when they go to the site for historical measurement and inspection.
Only in this way can we ensure that the production of fast doors is suitable for the user's installation site, is the unique high-quality products.
Function is used to say, belong to layman, therefore, simply can be measured under the guidance of the manufacturer, but because not professional, inevitably there will be errors, for the special situation of the scene is not good to make a clear judgment.
Therefore, in order products in Longshengmen, Wuhai Accumulation Gate is customized for free, because we have offices in Hohhot, Baotou, Wuhai, Chifeng, Tongliao, Ordos, Hulunbeir, Bayannaor, Ulanchab, Ulanhaote, Xilinhaote, Alxa League and other places.
If users need to order our products, we will arrange the staff of the nearest office to measure, see the scene and work out the production plan for you.
Since the rapid curtain door entered the country, many shops have chosen this door, almost all the shopping malls can be seen. Fast curtain doors are elegant in appearance and easy to clean, mainly because they are clear in themselves. They can tell consumers directly the essence of the store, that is, what products the store operates.
What do you see on the spot when you make the express door?
Looking at the construction of the rolling shutter doors on site and choosing the types of rolling shutters according to the practice environment, it is necessary to stabilize the head plates and guide rails at both ends of the equipment. For double-track and double-curtain equipment, it is necessary to consider that the thickness of the equipment of two guideways at each end must be up to 400 mm, and the thickness of the closing plate of the main engine should be 900 mm.
For pipeline bridges with water, electricity, etc., which have to pass through curtain door openings, it is common practice to place the equipment on the wide side of the door openings, seal the door openings with bricks and stones at the side of the pipes, and then measure them; or to put the equipment on the top of the pipe bridges to reduce the orientation of the door head equipment and the useful net height of the door openings, and then seal them with fire-proof curtain material. Blockage, useful to veto the spread of fire.
For determining and planning the orientation of the head plate and guide rail of the two ends of the equipment, the opening of the door is measured with tape measure. The width is equal to the distance between the back of the two ends of the guide rail, and the height is equal to the distance from the ground to the top of the head plate. If plugging is needed for middle installation, width = curtain width, height = distance from top of building to top of guide rail + 50mm.
For the building openings that violate the police rules, we should take full account of the orientation of the head plates and guideways (or double guideways) of the stabilizing equipment, and use masonry, angle steel, H steel and other materials to reinforce or support them. For those whose width or height is obstructed, we only need to reduce the width or height of the equipment, and then use masonry or fire-proof materials to block them.